Cam's Eldo

Cam's Eldo

Cam's Eldo

« 1 2 3 4 5 6 7 8 9 10 »

Adapter junction covered with heat shrink tube and plugged into the terminal on the alternator.

Adapter junction covered with heat shrink tube and plugged into the terminal on the alternator.

Next, connected the supplied red wire to the terminal of the alternator...

Next, connected the supplied red wire to the terminal of the alternator...

... and then to the positive terminal of the coil.

... and then to the positive terminal of the coil.

How it all looks so far

How it all looks so far

The supplied black wire connects to the stud on top of the alternator. This is just a test fit to sort hardware (not supplied).

The supplied black wire connects to the stud on top of the alternator. This is just a test fit to sort hardware (not supplied).

Reused the rubber boot that was on the red & red/white wires.

Reused the rubber boot that was on the red & red/white wires.

Tightened down and covered.

Tightened down and covered.

Wires will be secured to the main harness when I'm done.

Wires will be secured to the main harness when I'm done.

At the back end of the harness, heat shrinked the unused wires here as well.

At the back end of the harness, heat shrinked the unused wires here as well.

Since the (unnecessary) regulator is removed completely, wires are connected with an M6 bolt (not supplied).

Since the (unnecessary) regulator is removed completely, wires are connected with an M6 bolt (not supplied).

Then heat shrinked.

Then heat shrinked.

Unused wires are folded up onto the harness and zip-tied.

Unused wires are folded up onto the harness and zip-tied.

Regulator removed, bracket cleaned and waxed, only the starter relay and bracket for the signal flasher remain.

Regulator removed, bracket cleaned and waxed, only the starter relay and bracket for the signal flasher remain.

Bracket mounted, relay connected.

Bracket mounted, relay connected.

Neutral switch connected, ground move to case.

Neutral switch connected, ground move to case.

« previous | next »

... and then to the positive terminal of the coil.

Print Photos | View Full-Size Image

... and then to the positive terminal of the coil.